EmailEmail Us Today: info@salessystemsltd.comPhoneCall Us Toll Free: 800.368.3711
Reference Guide Only. Not Actual Inventory.
Sales Systems Limited Products and Services > Fasteners Reference Guide > Bolts / Screws > Structural Bolting > Hardened Beveled Washers with Slope or Taper in Thickness 1:6 > Item # HBW1500XXX  
Download PDF Download PDF         Email Email This Page     Save To Favorites Save To Favorites

Item # HBW1500XXX, Hardened Beveled Washer with Slope or Taper in Thickness 1:6, 1-1/2" Nominal Dia.


Notes:
  • Dimensional Conformance. Beveled washers shall have the following characteristics inspected to ASME B18.18.2, to the inspection levels shown :
    Inside diameter - Inspection Level B
    Visual - Inspection Level C
    If verifiable in-process inspection is used.
  • Non-clipped washers may be rectangular providing neither side dimension is less than L, and one side may be longer than that of the L min included in the table.
  • Nominal washer sizes are intended for use with comparable nominal bolt diameters.
  • Clipped edge E shall not be closer than 0.875 times the nominal bolt diameter from the center of the washer.
Designated characteristics shall be inspected in accordance with ASME B18.18.2. For nondesignated characteristics, the provision of B18.18.1 shall apply. Should a non-designated dimension be determined to be outside its specified limits, it shall be deemed conforming to this standard if the user, who is the installer, accepts the dimension based on fit, form, and function considerations. Where verifiable in-process inspection is used..




Manufacturer  · Specifications  · Codes and Standards

Manufacturer

Manufacturer
Industrial Fasteners Institute


Specifications

Product
Structural Bolting

Unit of Measure
English

Nominal Washer Size1
1-1/2 in

Nominal Washer Size (Decimal)
1.5000 in

Nominal Inside Dia. (A)
1.625 in

Tolerance for Inside Dia. (A)
+0.0313 in
-0.000 in

Minimum Side Length (L)2
2.250 in

Thickness (T)
0.313 in

Nominal Edge Distance (E)3
1.313 in
1 Nominal washer sizes are intended for use with comparable nominal bolt diameters.
2 Nonclipped washers may be rectangular providing neither side dimension is less than L, and one side may be longer than that of the L min included in the table.
3 Clipped edge E shall not be closer than 0.875 times the nominal bolt diameter from the center of the washer.


Codes and Standards

Codes and Standards
ASME Draft Revision B18.2.6 2003


Distributor of Industry Standard and Military Specification Threaded Fasteners