EmailEmail Us Today: info@salessystemsltd.comPhoneCall Us Toll Free: 800.368.3711
Reference Guide Only. Not Actual Inventory.
Sales Systems Limited Products and Services > Fasteners Reference Guide > Nuts > Structural Bolting [Nuts] > Hex Slotted Nuts > Item # HSN03750XXX  
Download PDF Download PDF         Email Email This Page     Save To Favorites Save To Favorites

Item # HSN03750XXX, Hex Slotted Nut, 3/8" Nominal Dia.


  • Unification. Bold type indicates products unified dimensionally with British and Canadian standards. Unification of fine thread nuts is limited to sizes 1 in. and under.
  • Tops and Bearing Surfaces of Nuts. Nuts in sizes 5/8 in. nominal size and smaller shall be double chamfered. Larger size nuts shall be double chamfered or have washer faced bearing surface and chamfered top.
    The diameter of chamfer circle on double chamfered nuts and diameter of washer face shall be within the limits of the maximum width across flats and 95 percent of the minimum width across flats.
    The top of washer faced nuts shall be flat and the diameter of chamfer circle shall be equal to the maximum width across flats within a tolerance of minus 15 percent. The length of chamfer at hex corners shall be from 5 to 15 percent of the basic thread diameter. The surface of chamfer may be slightly convex or rounded.
    Bearing surface shall be flat and perpendicular to the axis of the threaded hole within the specified FIM limit.
  • Width Across Flats. Maximum width across flats shall not be exceeded. No transverse section through the nut between 25 and 75 percent of the actual nut thickness as measured from the bearing surface shall be less than the minimum width across flats. For milled-from-bar nuts, see statement in General Data pertaining to the nominal bar size to be used.
  • Corner Fill. A rounding or lack of fill at junction of hex corners with chamfer shall be permissible provided the width across corners is within specified limits at and beyond a distance equal to 17.5 percent of the basic thread diameter from the chamfered faces.
  • True Position of Tapped Hole. The axis of tapped hole shall be located at true position with respect to the axis of nut body within a tolerance zone having a diameter.




Manufacturer  · Specifications  · Codes and Standards  · Runout of Bearing Face, FIM

Manufacturer

Manufacturer
Industrial Fasteners Institute


Specifications

Product
Nuts

Unit of Measure
English

Nominal Size or Basic Major Dia. of Thread
3/8 in

Nominal Size or Basic Major Dia. of Thread (Decimal)
0.3750 in

Basic Width Across Flats (F)
9/16 in

Max. Width Across Flats (F)
0.562 in

Min. Width Across Flats (F)
0.551 in

Max. Width Across Corners (G)
0.650 in

Min. Width Across Corners (G)
0.628 in

Basic Thickness (H)
21/64 in

Max. Thickness (H)
0.337 in

Min. Thickness (H)
0.320 in

Max. Unslotted Thickness (T)
0.210 in

Min. Unslotted Thickness (T)
0.19 in

Max. Width of Slot (S)
0.15 in

Min. Width of Slot (S)
0.12 in


Codes and Standards

Codes and Standards
ASME/ANSI B18.2.2 1987 (R 1999)


Runout of Bearing Face, FIM

Max. Runout of Bearing Surface FIM
0.018 in


 DOWNLOADS 

Formulas for Nut Dimensions
(PDF, 296KB)

Wrench Openings for Square and Hex Nuts
(PDF, 244KB)


Distributor of Industry Standard and Military Specification Threaded Fasteners