Sales Systems, Limited
Sales Systems, Limited
700 Florida Avenue
Portsmouth, Virginia 23707
Toll Free: 800.368.3711
Phone: 757.397.0763
Fax Sales: 757.393.3669
Email: info@salessystemsltd.com
Website: www.salessystemsltd.com
Print Back
Notes:
  • Dimensional Conformance. Beveled washers shall have the following characteristics inspected to ASME B18.18.2, to the inspection levels shown :
    Inside diameter - Inspection Level B
    Visual - Inspection Level C
    If verifiable in-process inspection is used.
  • Non-clipped washers may be rectangular providing neither side dimension is less than L, and one side may be longer than that of the L min included in the table.
  • Nominal washer sizes are intended for use with comparable nominal bolt diameters.
  • Clipped edge E shall not be closer than 0.875 times the nominal bolt diameter from the center of the washer.
Designated characteristics shall be inspected in accordance with ASME B18.18.2. For nondesignated characteristics, the provision of B18.18.1 shall apply. Should a non-designated dimension be determined to be outside its specified limits, it shall be deemed conforming to this standard if the user, who is the installer, accepts the dimension based on fit, form, and function considerations. Where verifiable in-process inspection is used..
Unit of Measure

Manufacturer

Manufacturer

 N/A Industrial Fasteners Institute

Specifications

Product

 N/A Structural Bolting

Unit of Measure

 N/A English
Nominal Washer Size1 N/A 1/2 in

Nominal Washer Size (Decimal)

 N/A 0.5000 in

Nominal Inside Dia. (A)

 N/A 0.531 in

Tolerance for Inside Dia. (A)

 N/A +0.0313 in-0.000 in
Minimum Side Length (L)2 N/A 1.750 in

Thickness (T)

 N/A 0.313 in
Nominal Edge Distance (E)3 N/A 0.438 in

Codes and Standards

Codes and Standards

 N/A ASME Draft Revision B18.2.6 2003
  • 1 Nominal washer sizes are intended for use with comparable nominal bolt diameters.
  • 2 Nonclipped washers may be rectangular providing neither side dimension is less than L, and one side may be longer than that of the L min included in the table.
  • 3 Clipped edge E shall not be closer than 0.875 times the nominal bolt diameter from the center of the washer.