Print Back
  • Tops of Nuts. Tops of nuts shall be flat and chamfered or washer crowned. Diameter of the chamfer circle shall be equal to the maximum width across flats within a tolerance of minus 15 percent. The surface of chamfer may be slightly convex or rounded.
  • Width Across Flats. Maximum width across flats shall not be exceeded. No transverse section through the nut between 25 and 75 percent of the actual nut thickness as measured from the bearing surface shall be less than the minimum width across flats.
more
Unit of Measure

Manufacturer

Manufacturer

Industrial Fasteners Institute

Specifications

Product

Nuts

Unit of Measure

English

Nominal Size or Basic Major Dia. of Thread

1-3/8 in

Nominal Size or Basic Major Dia. of Thread (Decimal)

1.3750 in

Basic Width Across Flats (F)

2-3/16 in

Max. Width Across Flats (F)

2.188 in

Min. Width Across Flats (F)

2.119 in

Max. Width Across Corners (G)

3.094 in

Min. Width Across Corners (G)

2.879 in

Basic Thickness (H)

1-3/8 in

Max. Thickness (H)

1.409 in

Min. Thickness (H)

1.310 in

Codes and Standards

Codes and Standards

ASME/ANSI B18.2.2 1987 (R 1999)