Sales Systems Ltd. - Hardened Beveled Washers with Slope or Taper in Thickness 1:6

Notes:

Dimensional Conformance. Beveled washers shall have the following characteristics inspected to ASME B18.18.2, to the inspection levels shown :
Inside diameter - Inspection Level B
Visual - Inspection Level C
If verifiable in-process inspection is used.
Non-clipped washers may be rectangular providing neither side dimension is less than L, and one side may be longer than that of the L min included in the table.
Nominal washer sizes are intended for use with comparable nominal bolt diameters.
Clipped edge E shall not be closer than 0.875 times the nominal bolt diameter from the center of the washer.

Designated characteristics shall be inspected in accordance with ASME B18.18.2. For nondesignated characteristics, the provision of B18.18.1 shall apply. Should a non-designated dimension be determined to be outside its specified limits, it shall be deemed conforming to this standard if the user, who is the installer, accepts the dimension based on fit, form, and function considerations. Where verifiable in-process inspection is used..

Hardened Beveled Washers1 with Slope or Taper in Thickness 1:6

Unit of Measure

Items	HBW0500XXX Hardened Beveled Washer with Slope or Taper in Thickness 1:6, 1/2" Nominal Dia.	HBW0625XXX Hardened Beveled Washer with Slope or Taper in Thickness 1:6, 5/8" Nominal Dia.	HBW0750XXX Hardened Beveled Washer with Slope or Taper in Thickness 1:6, 3/4" Nominal Dia.	HBW0875XXX Hardened Beveled Washer with Slope or Taper in Thickness 1:6, 7/8" Nominal Dia.	HBW1000XXX Hardened Beveled Washer with Slope or Taper in Thickness 1:6, 1" Nominal Dia.
Manufacturer	N/A Industrial Fasteners Institute
Product	N/A Structural Bolting
Codes and Standards	N/A ASME Draft Revision B18.2.6 2003
Unit of Measure	N/A English
Nominal Washer Size¹	N/A 1/2 in	N/A 5/8 in	N/A 3/4 in	N/A 7/8 in	N/A 1 in
Nominal Washer Size (Decimal)	N/A 0.5000 in	N/A 0.6250 in	N/A 0.7500 in	N/A 0.8750 in	N/A 1.0000 in
Nominal Inside Dia. (A)	N/A 0.531 in	N/A 0.688 in	N/A 0.813 in	N/A 0.938 in	N/A 1.125 in
Tolerance for Inside Dia. (A)	N/A +0.0313 in-0.000 in
Minimum Side Length (L)²	N/A 1.750 in
Thickness (T)	N/A 0.313 in
Nominal Edge Distance (E)³	N/A 0.438 in	N/A 0.547 in	N/A 0.656 in	N/A 0.766 in	N/A 0.875 in
¹ Nominal washer sizes are intended for use with comparable nominal bolt diameters. ² Nonclipped washers may be rectangular providing neither side dimension is less than L, and one side may be longer than that of the L min included in the table. ³ Clipped edge E shall not be closer than 0.875 times the nominal bolt diameter from the center of the washer.