Email Us Today: 
Call Us Toll Free: 
- Surface Condition. Bolts need not be finished on any surface except threads.
- Top of Head. Top of head shall be full form and chamfered with the diameter of chamfer circle being equal to the maximum width across flats, within a tolerance of minus 15 percent.
- Head Taper. Maximum width across flats and across corners shall not be exceeded. No transverse section through the head between 25 percent and 75 percent of actual head height, as measured from the bearing surface, shall be less than the minimum width across flats and across corners.
- Bearing Surface. A die seam across the bearing surface is permissible. Bearing surface shall be perpendicular to the axis of the body within a tolerance of 3 deg for 1.
Unit of Measure
Specifications
Product |
N/A Square and Hex Bolts and Screws |
Unit of Measure |
N/A English |
Nominal Size or Basic Product Diameter |
N/A 2-1/2 in |
Nominal Size or Basic Product Diameter (Decimal) |
N/A 2.5000 in |
Max. Full-Size Body Diameter (E) |
N/A 2.559 in |
Min. Full-Size Body Diameter (E) |
N/A 2.461 in |
Basic Width Across Flats (F) |
N/A 3-3/4 in |
Max. Width Across Flats (F) |
N/A 3.750 in |
Min. Width Across Flats (F) |
N/A 3.625 in |
Max. Width Across Corners (G) |
N/A 4.330 in |
Min. Width Across Corners (G) |
N/A 4.133 in |
Basic Head Height (H) |
N/A 1-21/32 in |
Max. Head Height (H) |
N/A 1.708 in |
Min. Head Height (H) |
N/A 1.479 in |
Max. Radius of Fillet (R) |
N/A 0.19 in |
Min. Radius of Fillet (R) |
N/A 0.060 in |
