Headed Anchor Studs are designed for welding to flat surface or welding in the fillet or to the heel of angles. When ordering specify if studs are to be welded is fist surfaces or in fillet or to heel of angle. All orders for studs include required ferrules.

Length : Length is before weld. Stud diameters (D) 1/2" and below will be approximately 1/8" shorter after welding . 5/8" will be approximately 3/14" shorter after welding . Maximum length available for cold headed product is 8-3/16". Prices on hot formed studs over 8-3/16" available upon request.

Material : Low Carbon Steel

All S.W.A. headed anchor meet AWS specifications. Test report available on request.

Stainless Steel : HA studs are also available in stainless steel, Type 304 Other grades of stainless steel (except Type 303) available when required.
Boxed in 3/8 keg cartons.

For welding to fillet or heel of angle consult SWA representative for ferrule part number.