• Each end shall be square with the axis of each arm within 4 deg, and edges may be sharp or chamfered at the option of the manufacturer. The chamfer shall not exceed the values listed.
  • Material (Steel Alloy). The spline keys shall be fabricated from an alloy steel having two or more of the following alloying elements: chromium, nickel, molybdenum, or vanadium, in sufficient quantity to assure that the specified minimum hardness of 48 HRC at the surface for sizes up to and including 0.372 in., and 45 HRC for sizes over 0.372 in., is met when spline keys are hardened by quenching from the austenitizing temperature and tempered.
  • For plated keys, all dimensions are before plating. Because of the high hardness of these products, it is recommended that they not be electroplated.
  • Bits are available, but lengths have not been standardized.
  • Spline keys shall be furnished as Short Arm Series or Long Arm Series.
  • Designation. To promote uniformity and understanding in communications relating to products conforming to this standard, it is recommended that Spline Keys be designated in accordance with the following data, preferably in the sequence shown:
    (a) product name
    (b) designation of the standard
    (c) nominal key size
    (d) series
    (e) protective finish, if required

    Examples:

    Spline Key, ASME B18.3, 0.111 Short Arm Series
    Spline Key, ASME B18.3, 0.372 Long Arm Series, Nickel Plated
Unit of Measure

Manufacturer

Manufacturer

N/A Industrial Fasteners Institute

Specifications

Product

N/A Socket Screws

Unit of Measure

N/A English

Nominal Keys and Socket Size

N/A 0.372 in

Max. Major Dia. (M)

N/A 0.3720 in

Min. Major Dia. (M)

N/A 0.3705 in

Max. Minor Dia. (W)

N/A 0.3100 in

Min. Minor Dia. (W)

N/A 0.3085 in

Number of Splines

N/A 6

Max. Width of Space (N)

N/A 0.0975 in

Min. Width of Space (N)

N/A 0.0960 in

Max. Length (B)

N/A 1.344 in

Min. Length (B)

N/A 1.156 in

Max. Short Arm Series Length (C)

N/A 3.844 in

Min. Short Arm Series Length (C)

N/A 3.656 in

Max. Long Arm Series Length (C)

N/A 6.094 in

Min. Long Arm Series Length (C)

N/A 5.906 in

Min. Radius of Bend (R)

N/A 0.312 in

Max. Chamfer (K)

N/A 0.032 in

Codes and Standards

Codes and Standards

N/A ASME B18.3 2002
Use trailing wildcard (*) for broader results.